What you need to supply
●
A supported Microsoft Windows or Apple Macintosh computer with the included Network (LAN)
cable to configure wired and/or wireless settings.
For a wireless network: an 802.11b or 802.11g wireless LAN (WLAN) interface card installed in the
computer.
NOTE: Use the included LAN cable to avoid possible radio interference problems during
installation. After installation, you can remove the cable.
◦
Microsoft Windows XP, Vista, Server 2003, or Server 2008.
◦
Apple Mac OS X 10.2 and later.
◦
UNIX/Linux: Hewlett-Packard HP-UX, Sun Microsystems Solaris, IBM AIX, HP MPE-i, RedHat
Linux, SuSE Linux
If your network is entirely wireless, then a wireless computer is needed to set up a wireless
connection from your printer to your network.
●
For wireless infrastructure mode only: a wireless router, access point, or Apple base station.
In infrastructure mode, an access point is a device that connects wireless devices, such as a
wireless network printer, to your cabled network. See
Wireless LAN terms and concepts
on page 4 for more information.
●
For Windows systems: the printer’s software driver for your Windows system.
When using the HP Jetdirect CD-ROM to install a network printer, you need the software driver for
your printer. You can obtain your printer driver from one of the following sources:
◦
printing system CD-ROM supplied with your printer
◦
HP support Web site at:
www.hp.com/go/support.
◦
automated driver download feature of the HP Install Network Printer wizard on the HP Jetdirect
CD-ROM (If you have Internet access, the printer installation software on the HP Jetdirect
CD-ROM can automatically download and install the printer driver.)
NOTE: The HP Install Network Printer wizard requires a printer driver file with the appropriate
extension (*.inf) to complete the installation. The applicable drivers are commonly referred to as
the “Add Printer” drivers, or the “Corporate User” printer drivers.
2 Chapter 1 Introduction ENWW
To Next Page
Loading...
Need help?
General
