CAUTION: Resetting the HP Jetdirect wireless print server to factory-default settings can cause the
print server to lose its wireless connection to your network. Reconfiguration of wireless network settings
and reinstallation of the print server might be required.
If a printer reset is required, settings are reset to their factory default values. If you reset the printer, you
might need to reconfigure the printer’s settings that are required by users.
To restore factory-default settings on an HP Jetdirect ew2500 print server, follow these steps:
1. Unplug the power module from the back of the print server.
2. While holding down the test button on the back of the print server, plug the power module back
into the print server then release the test button. Any user-configured settings will be erased.
When you restore the print server to its factory-default settings, you should print an HP Jetdirect
configuration page to confirm that factory-default values have been assigned.
Interpret the status lights
The HP Jetdirect ew2500 status lights provide information about the USB, wired, and wireless
connections. The Link and Act status lights on the LAN connector indicate network activity.
1 USB
2 Wired
3 Wireless
4 Link (on LAN connector)
5 Act (on LAN connector)
ENWW Interpret the status lights 29
To Next Page
Loading...
Need help?
General
