Setting Up the Monitor
Removing the Monitor Base
You can remove the monitor base to mount the monitor on a
wall, a swing arm, or other mounting fixture. Read the caution
and warning statements below before beginning the procedure.
CAUTION: Before beginning to disassemble the monitor, be sure the
monitor is turned off and the power and signal cables are both
disconnected. If your monitor has a connected audio cable, disconnect it.
WARNING: Do not remove the base from the monitor while the monitor
is in the upright position. Lay the front bezel down on a soft area to
prevent it from getting scratched, defaced, or broken. Before removing
the monitor from the base, ensure that the base is set to the maximum
base extension. Attempting to remove the monitor from the base while
upright in the minimum base extension may result in injury to the user.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
User’s Guide 3-7
To Next Page
Loading...
Need help?
General