To Next Page

To Previous Page

3 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other

attached devices, then follow the instructions below.

Unfolding the Double-Hinged Monitor Pedestal Base

NOTE: The monitor is shipped with the base attached in a folded-flat position. To begin using the

monitor, you must unfold the base and place the monitor in an upright position.

1. Lift the monitor from its box and place it on a flat surface with the display head facing up.

2. Pivot the display head from portrait to landscape position (1).

Figure 3-1 Pivoting the Display Head

3. Press down on the rear hinge (2) while gently pulling up on the monitor display head (3).

4. Raise the monitor (4) to extend the pedestal base to the desired height.

CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-

uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover

to its normal condition.

Unfolding the Double-Hinged Monitor Pedestal Base 5

Other manuals for HP L1750

Questions and Answers:

Need help?

Do you have a question about the HP L1750 and is the answer not in the manual?

General

3D	No
Aspect ratio	16:9
Display diagonal	17 \
Display resolution	1280 x 1024 pixels
Vertical scan range	50 - 77 Hz
Horizontal scan range	24 - 83 kHz
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	800:1
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
Power consumption (standby)	- W
USB Type-A downstream ports quantity	0
Tilt angle range	-5 - 35 °
Panel mounting interface	- mm
Product color	Silver
Country of origin	China
Cables included	AC
Sustainability certificates	ENERGY STAR