b. On the single-hinged base, there are three screws that connect the monitor panel to the
pedestal base.
Figure 3-18 Removing the Single-Hinged Pedestal Base
4. Lift up on the pedestal base to remove it from the monitor display head.
Mounting the Monitor
HP provides an HP Flat Panel Monitor Quick Release (purchased separately) that installs to the back
of the monitor panel and allows you to quickly and securely attach the panel to a wall or swing arm
mounting fixture. To install the HP Quick Release:
1. Remove the monitor panel from the pedestal base. Refer to
Removing the Monitor Pedestal
Base on page 16 steps in the previous section.
CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach
a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are
required. Longer screws should not be used because they may damage the monitor. It is important
to verify that the manufacturer’s mounting solution is compliant with the VESA standard and is rated
to support the weight of the monitor display panel. For best performance, it is important to use the
power and video cables provided with the monitor.
2. Set the monitor panel down on a flat, soft, protected surface.
Removing the Monitor Pedestal Base 17
To Next Page
Loading...
Need help?
General
Weight and Dimensions
