To Next Page

To Previous Page

Connecting the Cables

1. Place the monitor in a convenient, well-ventilated location near the computer.

2. Connect a VGA signal cable or DVI-D signal cable.

NOTE: For models with both VGA and DVI-D connectors, the monitor is capable of supporting

either analog or digital input. The video mode is determined by the video cable used. The monitor

will automatically determine which inputs have valid video signals. The inputs can be selected by

pressing the +/Input button on the front panel or through the On-Screen Display (OSD) feature by

pressing the Menu button.

●

For analog operation, use the VGA signal cable provided. Connect the VGA signal cable to

the VGA connector on the rear of the monitor and the other end to the VGA connector on the

computer.

●

For digital operation, use the DVI-D signal cable provided (select models). Connect the DVI-

D signal cable to the DVI connector on the rear of the monitor and the other end to the DVI

connector on the computer.

Figure 3-8 Connecting the Signal Cable

3. Connect the built-in monitor speakers (on select models) to the computer using the audio cable.

10 Chapter 3 Setting Up the Monitor

Other manuals for HP L1750

Questions and Answers:

Need help?

Do you have a question about the HP L1750 and is the answer not in the manual?

General

3D	No
Aspect ratio	16:9
Display diagonal	17 \
Display resolution	1280 x 1024 pixels
Vertical scan range	50 - 77 Hz
Horizontal scan range	24 - 83 kHz
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	800:1
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
Power consumption (standby)	- W
USB Type-A downstream ports quantity	0
Tilt angle range	-5 - 35 °
Panel mounting interface	- mm
Product color	Silver
Country of origin	China
Cables included	AC
Sustainability certificates	ENERGY STAR