196 Getting Started (features vary by model)
7 Click Browse to select a place to save the files, and then click OK.
8 Click Filename to specify a file name for the captured video file.
9 Click Done to add the captured video file automatically to the movie project.
Capturing recorded video from a DV camera
For best results when using muvee autoProducer, capture only video footage that you are
most interested in using in the movie project.
To capture recorded video to the hard disk drive:
1 Connect the DV camera to the FireWire (IEEE 1394) port on the computer.
2 Turn on the camera, and set it to VCR mode. Refer to the instructions in the
manufacturer’s documentation.
3 Click the Import Video/Pictures from a device button.
4 Select From My Camcorder.
5 Click the Play button to start viewing the video.
6 Click Start Capture when you see the start of the video footage that you want to use
in the movie project.
7 Click Stop Capture to stop capturing.
8 Repeat steps 5 and 6 to capture additional sections of video footage.
9 Click Capture Folder to specify a folder for the captured video file.
10 Click Filename to specify a file name for the captured video file.
11 Click Done to automatically add the captured video files to the movie project.
Adding videos
To add video files to the movie project:
1 Click the Add video button in the Video/Pictures area. The Add Video
window opens.
2 Browse the folders on the hard disk drive to select existing video files for the
movie:
 Add up to three video files.
 Select multiple video files by pressing and holding the Ctrl key on the keyboard
while you select the files.
To Next Page
Loading...
Need help?
General