HP ProBook 4325s User Manual

2. Loosen the Phillips PM2.5×10.0 captive screw (1) that secures the hard drive to the computer
and remove the two Phillips PM2.0×3.0 screws (2).
3. Grasp the Mylar tab on the hard drive and slide the hard drive (1) to the left to disconnect it from
the system board.
4. Remove the hard drive (2) from the hard drive bay.
5. If it is necessary to replace the hard drive bracket, remove the two Phillips PM3.0×3.0 hard drive
bracket screws (1) from each side of the hard drive.
62 Chapter 4 Removal and replacement procedures

HP ProBook 4325s Specifications

General

Brand	HP
Model	ProBook 4325s
Category	Laptop
Language	English