12-44
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Displaying Switch Information Available for Outbound
Advertisements
These commands display the current switch information that will be used to
populate outbound LLDP advertisements.
For example, in the default configuration, the switch information currently
available for outbound LLDP advertisements appears similar to the display in
figure 12-13 on page 12-45.
Syntax show lldp info local-device [ port-list ]
Without the [ port-list ] option, this command displays the global
switch information and the per-port information currently
available for populating outbound LLDP advertisements.
With the [ port-list ] option, this command displays only the
following port-specific information that is currently available
for outbound LLDP advertisements on the specified ports:
•PortType
• PortId
•PortDesc
Note: This command displays the information available on
the switch. Use the lldp config < port-list > command to change
the selection of information that is included in actual
outbound advertisements. In the default LLDP configuration,
all information displayed by this command is transmitted in
outbound advertisements.
To Next Page
Loading...
Need help?
General