HP ProCurve 2510 User Manual

12-46
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Displaying Advertisements Currently in the Neighbors MIB. These
commands display the content of the inbound LLDP advertisements received
from other LLDP devices.
Syntax: show interfaces brief < port-list >
Includes port speed and duplex configuration in the Mode
column of the resulting display.
Syntax: show lldp info remote-device [ port-list ]
Without the [ port-list ] option, this command provides a global
list of the individual devices it has detected by reading LLDP
advertisements. Discovered devices are listed by the inbound
port on which they were discovered. Multiple devices
listed for
a single port indicates that such devices are connected to the
switch through a hub.
Discovering the same device on multiple ports
indicates that
the remote device may be connected to the switch in one of the
following ways:
– Through different VLANS using separate links. (This
applies to switches that use the same MAC address for all
configured VLANs.)
– Through different links in the same trunk.
– Through different links using the same VLAN. (In this
case, spanning-tree should be invoked to prevent a net-
work topology loop. Note that LLDP packets travel on
links that spanning-tree blocks for other traffic types.)
With the [ port-list ] option, this command provides a listing of
the LLDP data that the switch has detected in advertisements
received on the specified ports.
For descriptions of the various types of information displayed
by these commands, refer to Table 12-1 on page 12-29.

HP ProCurve 2510 Specifications

General

Layer	Layer 2
Operating Humidity	15% to 95% non-condensing
Model	HP ProCurve 2510
Switching Capacity	8.8 Gbps
Forwarding Rate	6.6 Mpps
Management	Web, CLI, SNMP
Dimensions	4.4 x 44.3 x 25.4 cm
Jumbo Frame Support	Up to 9216 bytes
Operating Temperature	0°C to 45°C
Weight	6.61 lbs (3 kg) (24-port), 9.92 lbs (4.5 kg) (48-port)

Summary

Getting Started

Introduction

Describes the purpose and content of the Management and Configuration Guide for ProCurve Series 2510 Switches.

Selecting a Management Interface

Advantages of Using the Menu Interface

Advantages of Using the CLI

Using the Menu Interface

Using the Command Line Interface (CLI)

Privilege Levels at Logon

Using the Web Browser Interface

Switch Memory and Configuration

Overview of Configuration File Management

Explains the switch's two configuration files: running-config and startup-config.

Using the CLI To Implement Configuration Changes

Details how to use CLI commands to view and reconfigure switch features, including saving changes.

Interface Access and System Information

Interface Access: Console/Serial Link, Web, and Telnet

Configuring IP Addressing

IP Configuration

Details IP configuration features including IP address, subnet mask, and default gateway settings.

Time Protocols

Port Status and Basic Configuration

Viewing Port Status and Configuring Port Parameters

Port Trunking

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

Covers managing the switch via SNMP using applications like ProCurve Manager.

LLDP (Link-Layer Discovery Protocol)

File Transfers

Downloading Switch Software

Monitoring and Analyzing Switch Operation

Status and Counters Data

Troubleshooting

Troubleshooting Approaches

Chassis Over-Temperature Detection

MAC Address Management

Overview

Describes how the switch assigns MAC addresses for management functions and internal operations.

CLI: Viewing the Port and VLAN MAC Addresses