To Next Page

To Previous Page

Configuring Port-Based Access Control (802.1x)

Configuring Switch Ports as 802.1x Authenticators

Configuring Switch Ports as 802.1x

Authenticators

802.1x Authentication Commands Page

[no] aaa port-access authenticator < [ethernet] < port-list > 8-14-

[control | quiet-period | tx-period | supplicant-timeout |

8-14-

server-timeout | max-requests | reauth-period | auth-vid |

unauth-vid | initialize | reauthenticate | clear-statistics]

aaa authentication port-access 8-18-

< local | eap-radius | chap-radius >-

[no] aaa port-access authenticator active 8-14-

[no] port-security [ethernet] < port-list > learn-mode port-access 8-31-

802.1x Open VLAN Mode Commands 8-20-

802.1x Supplicant Commands 8-33-

802.1x-Related Show Commands 8-37-

RADIUS server configuration 8-19-

1. Enable 802.1x Authentication on Selected Ports

This task configures the individual ports you want to operate as 802.1x

authenticators for point-to-point links to 802.1x-aware clients or switches.

(Actual 802.1x operation does not commence until you perform step

5 on page

8-12 to activate 802.1x authentication on the switch.)

Note When you enable 802.1x authentication on a port, the switch automatically disables

LACP on that port. However, if the port is already operating in an LACP trunk, you

must remove the port from the trunk before you can configure it for 802.1x authen

tication.

8-14

Brand

Model

ProCurve 5300xl Series

HP ProCurve 5300xl Series Access Security Guide

Other manuals for HP ProCurve 5300xl Series