Hardware options installation 12
Hardware options installation
Introduction
If more than one option is being installed, read the installation instructions for all the hardware options
and identify similar steps to streamline the installation process.
For HP-supported options, refer to the Quickspecs on the HP website
(http://www.hp.com/servers/proliant
).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
CAUTION: Before installing any options, power down the server to prevent damage to the
server and the equipment ("Power down the server" on page 5).
Processor option
For server-specific processor installation instructions, refer to the installation instructions included with the
processor option kit.
CAUTION: To prevent possible server malfunction and damage to the equipment, do not mix
processors of different types or speeds.
Optical drive option
For server-specific optical drive installation instructions, see the installation sheet included with the option
kit.
Memory options
For server-specific memory installation guidelines, refer to the installation sheet included with the server.
PCI I/O device option
For server-specific PCI I/O device installation instructions, see the installation instructions included with the
PCI I/O device option kit.
To Next Page
Loading...
Need help?
General