To Next Page

To Previous Page

Installation and configuration 25

Connecting the UPS cord retention clips

Charging the UPS batteries

With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service.

IMPORTANT: Charge the batteries for at least 24 hours before supplying backup power to

devices. The batteries charge to:

• 80 percent of their capacity within 3 hours

• 100 percent of their capacity within 48 hours

Starting power to the load

Start power to the load by placing the UPS in Operate mode.

IMPORTANT: AC power must be available the first time the UPS is started.

Configuring the UPS Network Module

NOTE: For more information about the UPS Network Module, see the HP Infrastructure

Management Pack software CD and documentation for complete details.

Before configuring the UPS Network Module, be sure that the network cable is connected.

Connecting the configuration cable

1. Connect the DB-9 connector on the DB-9 to RJ-45 cable to a serial connector on the host computer.

Other manuals for HP R5000

Questions and Answers:

Need help?

Do you have a question about the HP R5000 and is the answer not in the manual?

General