Power connector cable
Table 5-11 Power connector cable description and part number
Description Spare part number
Power connector cable 810327-004
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 23).
2. Remove the bottom cover (see Bottom cover on page 24).
3. Disconnect the battery cable from the system board (see Battery on page 25).
4. Remove the display assembly (see Display assembly on page 36).
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector (2) from the retention clips built into the bottom cover.
3. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Component replacement procedures 43
To Next Page
Loading...
Need help?
General