In V200R020C00 and later versions, the
switch does not have a default console port
login password. You need to set a password
when you log in to the switch through the
console port for the first time.
NOTE
11
Copyright © Huawei Technologies Co., Ltd. 2021. All rights reserved.
No part of this document may be reproduced or
transmitted in any form or by any means without prior
written consent of Huawei Technologies Co., Ltd.
and other Huawei trademarks are trademarks
of Huawei Technologies Co., Ltd.
All other trademarks and trade names
mentioned in this document are the property
of their respective holders.
Supplier’s Declaration of Conformity (SDoC)
Unique Identifier: trade name: HUAWEI; product name: Switch;
model number: S2700&3700&5700&6700 series switches
Responsible Party- U.S. Contact Information
Huawei Technologies USA Inc.
5700 Tennyson Parkway, Suite 500
Plano, Texas 75024
Main: 214-919-6000 / TAC Hotline: 877-448-2934
FCC Compliance Statement ( for products subject to Part 15)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
You can run commands to configure the device. Enter a question mark (?) whenever you need help. For
more information, see the for your switch on the Huawei support website.
Press Enter in subsequent steps until the following information is displayed on the terminal
simulation software, and then enter a password. The default username and password are available
in S Series Switches Default Usernames and Passwords. If you have not obtained the access
permission of the document, see Help on the website to find out how to obtain it.
Step 3
Login authentication
Username:admin
Password:
Warning: The default password poses security risks.
The password needs to be changed. Change now? [Y/N]: y
Please enter old password:
Please enter new password:
Please confirm new password:
The password has been changed successfully
<HUAWEI>
The password entered in interactive mode is not displayed on the screen.
If you do not change the authentication mode and password after entering the user view, the
authentication password used for next login is the one configured during the first login.
Log in to Huawei enterprise technical support website (https://support.huawei.com/enterprise),
and select a specific product model and version to find its documentation.
Log in to Huawei enterprise support community
(https://forum.huawei.com/enterprise/en/index.html) and post your questions in the
community.
10 Obtaining Product Documentation and Technical Support
Trademarks and Permissions
Huawei Enterprise
Technical Support
Qualification Card
PASS
Configuration Guide
Open Source Software Notice
The Open Source Software Notice lists notices on open source software components used by the
product. Visit Huawei enterprise technical support website for the Open Source Software Notice.
Parity bit: None
Stop bit (S): 1
Flow control mode: None
To Previous Page
Loading...
Need help?
General