Figure 1 Hunter Model Mini-Clik
®
EN
The NODE can easily be mounted on any Hunter plastic valve. A
specially designed valve mounting clip makes installation a snap. A
protective rubber cover is provided to prevent dirt from accumulating
on the face of the NODE.
To Mount the NODE to a Valve (Figure 1)
. Screw the Hunter DC latching solenoid (P/N ) into
the valve bonnet.
. Set the small open end of the NODE holder on top of the solenoid.
. Set the NODE controller into the large open end of the
NODE holder.
A Hunter Mini-Clik
®
or Wired Rain-Clik
®
rain sensor can be connected
to the NODE. The purpose of this sensor is to stop watering when
weather conditions dictate.
1. Cut the yellow wire loop attached to the NODE at approximately
the middle of the loop.
2. Remove approximately ½" (13 mm) of insulation from each wire.
Attach one yellow wire to each of the wires of the weather sensor.
You can mount the rain sensor up to 100 (30 m) from the NODE
controller (18 AWG/1 mm minimum wire size).
3. Secure wire connections with waterproof connectors.
CONNECTING A WEATHER SENSOR
NOTE: When the Wired Rain Sensor is interrupting
the watering, the display will show the System O
icon , “OFF” and on the display.
MOUNTING THE NODE
NODE holder
6
To Next Page
Loading...
Need help?
General
