Hunter SRC Plus Product Information Guide

14
15
AC AC R RS C MV 1 2 3 4 5 6
9 V Battery
Sensor Wire to Common
Valve Common to RS
Hunter Weather Sensor
Connect Common to
this Terminal when
using Rain Sensor
Connect Rain Sensor Wires
to These Two Terminals
Sensor Wire to Weather Sensor
RESET
Connecting a Weather Sensor
A Hunter Mini-Clik
®
rain sensor or other
type of interrupt weather sensor can be
connected to the SRC Plus. The purpose
of this sensor is to stop watering when
precipitation is sufcient. The sensor
connects directly to the controller and
allows you to easily override the sensor
by using the RUN (BYPASS SENSOR)
position on the dial.
1. Route the wires from the rain sensor
up through the same opening used for
valve wiring.
2. Connect one wire to the RS terminal
and the other to the C terminal.
3. Connect the valve common from the
eld to the RS terminal.
NOTE: If a pump relay is
being used, the relay common
must also be connected to the
RS terminal.
INSTALLATION (continued)

Hunter SRC Plus Specifications

General

Brand	Hunter
Model	SRC Plus
Category	Controller
Language	English