30
31
TROUBLESHOOTING GUIDE
PROBLEM CAUSES SOLUTIONS
Transmitter display is blank. Transmitter is off. Press any button for 1 second.
Can’t access all the desired station on the
Transmitter.
Maximum station number is set wrong. See “Changing the Maximum Number”.
Receiver doesn’t beep two times after
plugging it in.
SmartPort
®
is not connected properly.
Controller has no power.
Recheck SmartPort
®
wiring.
Check controller power.
Receiver beeps twice after plugging it in,
but won’t respond to Transmitter.
Receiver and Transmitter address don’t
match.
Relearn address at receiver.
Transmitter display stays on. Transmitter will turn off automatically. Wait approximately 5 minutes without
pressing any buttons. Transmitter will “fall
asleep.”
“ERR” message in controller display when
controller is in the radio run position.
SmartPort
®
wiring leads have been
extended and are receiving radio
interference.
Replace lengthened wire with shielded
cable to prohibit interference. Use Hunter
SRR-SCWH.
Receiver does not receive signal from
remote held at close range.
Mismatch of addresses in transmitter and
receiver.
Reset address of receiver.
Remote has short range (i.e. less range
than 100 feet).
Check for interference causes. See “Maximizing Operating Range” and “A
Word About Range” on page 29.
To Next Page
Loading...
Need help?
General
