HUROM HH series Manual

18 19
3
DISASSEMBLING AND CLEANING THE SPINNING BRUSH
2
Detach the silicone brush from the
spinning brush.
With the cleaning brush, wash inside
and outside of spinning brush under
running water.
As shown in the figure, hold the outer part of silicone
brush and pull it out gently in the direction of the
arrow. Silicone brush may be torn or damaged if it is
pulled apart forcefully.
Clean the silicone brush in the same way under run-
ning water.
Remove the spinning brush from
strainer.
1
ASSEMBLING THE SPINNING BRUSH
As shown in the figure on left, position
the silicone brush so the ‘inner wing’
faces the spinning brush.
See No. 1 above and let the longer part of inner
wing
1
face upward.
Hold the outer wing
2
of silicone brush with your
thumb and index finger and insert the inner wing into
the groove of spinning brush.
Check the groove of the spinning brush
and the direction of silicone brush.
There are grooves to insert silicone brush in the
spinning brush.
Silicone brush has inner wing
1
and outer wing
2
.
As shown in the figure on left, position the silicone
brush so the ‘inner wing’ faces the spinning brush.
Pull the inner wing tightly into the spin-
ning brush.
Push the silicone brush in from the outside and pull
the ‘inner wing’ into the spinning brush with the other
hand. (See figure)
Pull the silicone brush tightly into the groove on the
spinning brush. The unit may be damaged if it is op-
erated without being properly and fully assembled.
Make sure the silicone brush is placed firmly into
the groove by holding the top and bottom part of
the ‘outer wing’ and pulling it up and down in op-
posite directions.
3
2
1
Brush
groove
Inner
wing
Outer wing
1
2
SPINNING BRUSH SILICONE BRUSH
Top
(longer part)
Bottom
(shorter part)
Silicone brush
Cleaning brush
Spinning brush
1
2

HUROM HH series Specifications

General

Brand	HUROM
Model	HH series
Category	Juicer
Language	English