12 13
DO NOT OPERATE SWITCHES WITH WET HANDS.
It may cause electric shock or fire.
Do not put foreign objects on or near the switch.
IMPORTANT SAFEGUARDS FOR USE
NEVER INSERT FINGER, FORK OR SPOON, ETC. INTO THE JUICER OUTLET DUR-
ING OPERATION.
Inserting foreign objects into the juice outlet during operation may cause the spinning bush to become stuck and damage
the parts.
USE ONLY THE PUSHER TO PRESS DOWN THE INGREDIENTS.
Any other objects may damage the parts and cause injury or failure of equipment.
DO NOT PLACE GRAINS, FRUIT WITH HARD SEED OR NUTS WITH HARD SHELL
SUCH AS WALNUTS INTO THE JUICER.
It may damage the chamber, auger, squeezing strainer, etc.
Fruits with pits, hard seeds such as nectarines, peaches, mangos, apricots, plums and cherries must be pitted before juicing.
DO NOT USE IT FOR MORE THAN 30 MINITUES CONTINUOUSLY.
It may cause a failure due to overheating of the motor.
When using continuously, stop and cool it down for about 5 minutes after each use.
Frozen fruit or withered ingredients that have been stored in the refrigerator for a long time may produce less juice or may be difficult to
juice.
NOTE
DO NOT USE FOR FRUIT PRESERVED IN SUGAR, HONEY, ALCOHOL, ETC.
(GRAPES, APRICOT, BERRES, ETC.)
It may cause the hopper to become stuck and difficult to open.
DO NOT USE FOR MEAT OR SEAFOOD.
It may cause abnormal performances or a failure.
· Fruits with pits and hard seeds such as nectarines, peaches, mangos, apricots, plums and cherries must be pitted before juicing.
· Cut fibrous ingredients (water parsleys, etc) into small sizes about 3~4cm(1.5inch) before placing into the hopper chute.
· Drink the fruit juice or green vegetable juice immediately after extraction.
The juice will lose taste and nutritional value longer it is exposed to air.
· Do not use the appliance for grinding dry ingredients such as grains, coffee beans, etc.
This may damage the parts or cause failure of the appliance.
· Do not re-squeeze leftovers expelled through the pulp outlet.
· Do not operate the appliance when the chamber is empty.
If the auger does not work even after following the di-
rections above, unplug the power cord form the electrical
outlet, disassemble and clean the chamber set before at-
tempting again.
Normal
direction
(ON)
WHEN THE AUGER IS STOPPED DURING OPERATION (REVERSE/REV BUTTON)
1
2
3
Reverse
direction
(REV)
Stop
NOTE
Reverse button pushes the ingredients back up.
Reverse only works while the button held down.
The Reverse rotation of the auger stops once the
button is released.
Click the [Reverse/REV] button on the
operating switch and stop the appli-
ance.
Press the [Reverse/REV] on the operat-
ing switch for 3~5 seconds and release
it. Repeat this process 2~3 times.
After the rotation stops completely,
press [ON] button to operate.
Before changing the rotation direction of the auger,
make sure that auger has come to a complete stop.
To Next Page
Loading...
Need help?
General
