18 - English
3. INSTALLATION
3.1 Preparations
1. If the lawn in the proposed working area is taller
than 10 cm, mow it using a normal lawn mower.
Then collect the clippings.
2. Read carefully through all the steps before the
installation.
3. Check that all parts for the installation are
included:
The numbers in brackets refer to the detail
diagram
2.1 Automower™, what’s what?
on
page 11.
• Operator’s Manual (26)
• Automower
• Charging station (15)
• Loop wire for the boundary wire and guide wire
(18)
• Transformer (19)
• Low voltage cable (20)
• Staples (21)
• Connector for the loop wire (22)
• Nails (23)
• Measurement gauge (24)
• Solderless coupler for the loop wire (25)
During installation you will also need: A hammer to
knock the staples into the ground, combination pliers,
and a straight spade if the boundary wire is to be
buried.
3.2 Installation of the charging
station
Ideal position of the charging station
For examples of good positioning of the charging
station, see
7. Garden example
on page 63.
If you are going to install a guide wire, read
3.8
Installation of the guide wire
, see page 33, before
choosing the position of the charging station.
The charging station must be positioned with a great
deal of free area in front of it (at least 3 metres). It
should also be positioned centrally in the working
area so that Automower can easily find the charging
station and quickly reach all parts of the working area.
It is a good idea to place the charging station in the
shadow. The battery is spared if it is charged in the
lowest possible ambient temperature.
3012-512
3012-510
To Next Page
Loading...
Need help?
General
