Battery charger
LED on the battery
charger
Cause Solution
The error LED flash-
es.
The temperature in the work en-
vironment is too high or too low.
Use the battery charger in temperatures between 5°C
and 40°C.
The error LED is on. Speak to an approved service agent.
Control panel
For problems, other than those in this section, speak to
your service agent.
Keypad Possible faults Possible action
Error LED flashes The motor is overloaded Increase the cutting height. See
To set the cutting
height on page 16
.
The motor speed drops too much,
and the motor stops
The motor control is too hot Stop the motor and wait until it has become cool
The blade is blocked To prevent accidental start turn the safety key to
0, remove the battery and wait a minimum 5 sec-
onds. Make sure that the blade can rotate freely. If
the problem continues, speak to an authorised
service agent
Battery error or no signal from battery Put the battery in the product correctly and exam-
ine the battery connector. If the error LED on the
battery flashes, see
Battery on page 22
.
The product stops The battery is weak Charge the battery. See
To charge the battery on
page 16
.
Battery connector failure Examine the battery connector
Transportation, storage and disposal
To set the product in transport position
1. Remove the grass catcher (if installed).
2. Loosen the knobs on the upper handle and fold the
handle down.
1626 - 004 - 23
To Next Page
Loading...
Need help?
General
