14
CONTROLS
Blade Switch
Ignition Switch
To engage the mower deck, pull the knob out;
mower blades are disengaged when the knob is
pressed down.
The ignition switch is placed on the control panel
and is used to start and stop the engine. On
models equipped with headlights, turn the key
clockwise to ACCESSORY for headlight use.
Service Meter
The service meter displays the total number of
hours the engine has run and indicates when the
engine and mower need servicing.
After every 50 hours of operation, an oil can icon
will appear and stay on for two hours, before an
automatic reset occurs. To manually reset the
the meter, turn the key off and on ve times at
one second intervals. To service the engine and
mower, see the Service Journal of this manual.
Note: The service meter operates (clocks hours)
only when the engine is running. Be sure to turn
the key off when the unit is not in use, to prevent
meter hours from accumulating.
Choke Control
The choke control is used for cold starts to
provide the engine with a richer fuel mixture.
For cold starts, pull the control up.
Seat Adjustment Lever
The seat can be adjusted lengthways. The lever
under the front edge of the seat is moved to the
left (as seen by the driver in the seat), to adjust
the seat backward or forward.
IMPORTANT INFORMATION Seat must not
be adjusted while unit is in motion.
To Next Page
Loading...
Need help?
General
