4. Move the steering / park brake controls out to the locked
position.
5. Move the throttle lever to the full throttle position.
NOTE: There is a detent at the full throttle position to aid in
setting the control.
6. Press in and turn the ignition key to the start position.
7. When the engine starts, immediately release the ignition
key back to the run position.
8. Set the engine speed with the throttle. Allow the engine to
run at a moderate speed, approximately mid throttle, for a
short time before use.
9. USE FULL THROTTLE WHEN MOWING.
Running
1. Release the park brake by pulling the steering / park
brake controls inwards to the neutral position.
NOTE: The mower is equipped with an operator presence
system. When the engine is running, any attempt by the
operator to leave the seat without first setting the park
brake will shut off the engine.
2. Lower the mower deck to the desired cutting height.
IMPORTANT INFORMATION Do not run the starter for
more than 5 seconds each time. If the engine does not
start, wait approximately 10 seconds before retrying.
If the temperature is below 32
O
F, move the throttle lever
up to the cold weather (snowflake) starting position.
When the engine has started, move the throttle lever back
to full throttle detent and allow the engine to warm up for a
short period before operating the unit. Failure to move the
throttle from the cold weather starting position will result in
poor engine performance, smoke and spark plug fouling.
WARNING! Make sure that no one is near mower
when engaging blade switch.
Make sure the work area is free from objects that could be
thrown by the rotating blades.
17
OPERATION
To Next Page
Loading...
Need help?
General
Weight and Dimensions
