TORCH SETUP
Duramax Retrofit Torch Operator Manual 2-13
Torch installation
Torches with a quick disconnect connector
1. Turn OFF the power switch and remove the power cord from the power receptacle.
2. Disconnect the gas supply hose from the power supply.
3. Align the connector key-way on the torch lead with the receptacle on the power supply and push in until the pins seat.
4. Before tightening, turn the connector securing ring 1/4 turn to the left to ensure that the securing ring threads and the
connector receptacle threads are aligned.
5. Turn the securing ring to the right to tighten.
6. Clean the top of the power supply and apply the new consumable label over the existing label.
Receptacle
Consumable label
(Part # 210126)
Securing ring
Key-way
Part Number Description
028522 MAX42 receptacle
028523 MAX43 receptacle
029962 Powermax800 receptacle
128493 Powermax600 receptacle
129325 Powermax900 receptacle
Note: If the receptacle is missing or damaged it should be replaced with a new receptacle.
Quick disconnect
connector
To Next Page
Loading...
Need help?
General
