Hypertherm Powermax 30 User Manual

TABLE OF CONTENTS
powermax30 Service Manual
vii
Component replacement ........................................................................................................................................3-22
Remove an endcap........................................................................................................................................3-22
Replace the torch lead...................................................................................................................................3-24
Replace the work lead....................................................................................................................................3-26
Replace the power cord (CSA) ......................................................................................................................3-27
Replace the power cord (CE).........................................................................................................................3-28
Replace the fan..............................................................................................................................................3-30
Replace the air filter element .........................................................................................................................3-31
Replace the air filter/regulator........................................................................................................................3-32
Replace the control board..............................................................................................................................3-33
Replace the power board...............................................................................................................................3-34
Replace the base...........................................................................................................................................3-37
Section 4 PARTS
Power supply parts ...................................................................................................................................................4-2
Exterior.............................................................................................................................................................4-2
Interior, power board side.................................................................................................................................4-3
Interior, fan side................................................................................................................................................4-4
T30v hand torch parts...............................................................................................................................................4-5
Safety-critical parts ...................................................................................................................................................4-6
Recommended spare parts ......................................................................................................................................4-7
Section 5 WIRING DIAGRAMS
Electrical schematic..................................................................................................................................................5-3

Hypertherm Powermax 30 Specifications

General

Gas Pressure	5.2 bar (75 psi)
Torch	Hand Torch
Input Voltage	120-240 V
Input Phase	1
Current Output	20-30 A
Cutting Thickness	10 mm (3/8 inch)
Max Severance Thickness	16 mm (5/8")
Max Clean Cut Thickness	10 mm (3/8 inch)
Weight	9.5 kg (21 lbs)
Gas Type	Air
Dimensions	356 mm D x 168 mm W x 305 mm H (14" D x 6.6" W x 12" H)