Powermax30/30 XP/30 AIR Field Service Bulletin 805430 13
Power Cord Replacement
Reinstall the rear panel
1. Push the rear panel into the base to re-engage the snaps.
2. Verify the hole in the ground wire clip is aligned with the screw holes in the rear panel and the power supply.
3. Tighten the retaining screw with a torque setting of 8.1 kg-cm (7 inch-pounds).
4. Reconnect the ground wire to the ground wire clip.
5. Tighten the strain relief nut on the power cord.
6. Hold the component barrier so that the edge with the long cutout and the two notches is closest to the rear panel,
and the edge with the three notches is closest to the front panel.
7. A perforated line runs across the top of the barrier, about 25 mm (1 inch) below the top edge. Fold the barrier along
this perforation so that the top edge bends away from you.
8. Position the barrier so that the folded section will cover the top of the power board. The edge with the long cutout
and the two notches should align with the front panel; the edge with the three notches should align with the rear
panel.
9. Put the front-panel edge of the barrier in place first, then the rear-panel edge. The notches on each side of the barrier
should align with the ribs on the inside of the front and rear panels. As you slide the barrier into place, make sure the
bottom edge is in the same track the cover rests in.
10. Being careful not to pinch any wires, slide the cover onto the power supply. Align the bottom edges with the tracks,
and align the slot in the top of the cover with the tab on the front panel so that the louvers in the cover are in front of
the fan.
Figure 12
1
Cover slot
2
Front panel
3
Tab
To Next Page
Loading...
Need help?
General
