OPERATION
Starting/Travelling/Stopping
With the direction control lever placed to
the neutral position, make sure the
parking brake is located at the operating
position.
With the accelerator pedal released
insert the start key into the key switch.
When the start key turned to "ON"
position, the drive control circuit of the
CHECKS PRIOR TO OPERATION
Inspection of battery make sure that the
battery has been fully charged.
Â
Voltage : 48V
Â
Specific gravity of electrolyte
: 1.28 (at 20
Á
C)
Make sure that the electrolyte level is
satisfactory.
Make sure that there is no loose connect-
ing plug. For handling refer to "Instruction
manual for battery".
3-1
33. OPERATING PROCEDURES
1. CHECKS PRIOR TO OPERATION
1)
(1)
Check the tightness on bolts of drive/idle wheels.
Check of brake
Check the brake pedal for pedalling allowance, and the parking brake for braking efficiency.
Check of steering system
Check that the steering wheel has no play.
(2)
(3)
(4)
BP157OM111
F.E.T is connected.
Place the direction control lever to the "Forward" position, and release the parking brake lever,
thereby the starting preparations are complete.
Step on the accelerator pedal slowly to start the battery tractor.
The travelling speed can be obtained optionally from almost zero-speed to the full-speed
according to the degree of the pedal stepped on.
Even if the accelerator pedal is stepped on suddenly, the truck will start smoothly without
applying any notable shock.
The fine movement and inching operations are also readily available, therefore, neither the
resistor will be heated and burnt, nor the electric power be wasted as in the case with the battery
tractor of resistance system even if the truck is operated for a long time.
2)
(1)
Η
Θ
Ι
Κ
Λ
Μ
Ν
Ξ
To Next Page
Loading...
General