4.5
Allow the engine to run for 10 seconds then squeeze the throttle to release the choke
in to the RUN position.
FROM WARM
4.6
Place the machine on flat level ground before starting.
4.7
Turn the ignition switch to the ‘I’ ON position.
4.8
Ensure the primer bulb has fuel inside.
4.9
Pull the recoil starter handle until you feel resistance.
Once you feel resistance, pull the recoil starter handle swiftly 3 to 5 times or until the
engine starts.
6. STOPPING PROCEDURE
5.0
Allow the engine to idle for 20 seconds under no load.
5.1
Turn the ignition switch to the ‘STOP’ position.
5.2
The machine should now stop.
7. USING THE MACHINE
CAUTION
Engine housing can become hot during trimmer operation.
DO NOT rest or place your arm, hand or any body part against the engine housing
during trimmer operation.
Extended contact with the engine housing can result in burns or other injuries.
ALWAYS position the unit on the operator’s right side.
The use of the machine on the operator’s left side will expose the user to hot
surfaces and can result in possible burn injuries.
To avoid burns from hot surfaces, NEVER operate the machine with the bottom
of the engine above waist level.
6.0
The cutting head spool will be engaged if the operator squeezes the throttle lever
and the squeezes the throttle lever release to increase the engine speed.
6.1
The engine will stop when depressing the switch to the ‘STOP’ position.
NOTE: This ignition switch will come back to the ‘ON’ position automatically.
6.2
Hold the trimmer with your right hand on the rear handle and your left hand on the
front handle.
6.3
Keep a firm grip with both hands while in operation.
6.4
Trimmer should be held at a comfortable position with the rear handle at about hip
height.
6.5
Keep your body and feet a safe distance from the cutting head.
6.6
Squeeze the throttle lever to full speed before cutting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
