Hyundai HYMT5080 User Manual

5 FUEL & OIL
5.1. Fuel and 2 stroke oil.
5.1.1. You MUST only use fresh unleaded fuel and 2 stroke engine oil mixture.
5.1.2. The oi/fuel ration mix is 40:1.
NEVER use neat petrol in your engine. This will cause permanent engine
damage and will invalidate the manufacturer's warranty of this product.
NEVER use a fuel mixture that has been stored for 90 days.
5.2. Fuel mixture.
5.2.1. Mix unleaded petrol with 2 stroke engine oil into an appropriate
container. Observe the mixture table for correct ratio of fuel to oil.
Unleaded
petrol
Two-stroke engine
oil (40: 1)
Unleaded
petrol
Two-stroke engine
oil (40:1)
1 Litre
0.025 Litre (25ml)
5 Litre
0.125 Litre (125ml)
2 Litre
0.050 Litre (50ml)
10 Litre
0.250 Litre (250ml)
5.2.2. Shake the container to ensure complete mixing.
Petrol is extremely flammable and sparks and naked flames can cause an
explosion.
5.2.3. Refuel only in a well ventilated area and allow engine to cool before filling.
5.2.4. Smoking and naked flames must be avoided as any sparks during refueling
5.2.5. Do not overfill the tank.
5.2.6. Check after refueling if the fuel tank cap is properly closed.
5.2.7. Avoid any spillage of petrol make sure all spillages are cleaned up
immediately.
5.2.8. Keep the machine away from children.
Page 17

Hyundai HYMT5080 Specifications

General

Engine Type	Single cylinder, 2 strokes, air-cooled engine, 1E43F-B
Engine size - cc	50.8CC
Start method	Recoil
Fuel tank capacity - ml	800ML
Fuel ratio/fuel type	40:1 Semi-Synthetic 2-Stroke oil/unleaded petrol
Noise Level - dB	117
Rated power - kw	1.56kw
Rated speed - rpm	7500 rpm
Cutter head - mm	400-450
Head Line diameter - mm x length - m	2.4 x 4
Cutter blade mm/teeth	1.6mm/3T
Cutting Width - mm/length - mm/ diameter - mm	255mm for cutter blade / 400-450 for cutter head
Chainsaw bar length – inches (mm)	12 (300)
Hedge Trimmer Blade length – inches (mm)	18 (450)
Clutch type	Centrifugal type

Weight and Dimensions

Gross weight - kg	14.50
Dry weight - kg	12.50
Box Dimensions - L x W x H - mm	1070 x 280 x 300
Chainsaw total length – mm	3270 (with extension pole)
Hedge Trimmer total length – mm	3440 (with extension pole)
Brush cutter total length – mm	1860