2130 PCMCIA Slot Assembly
Battery Pack (2020)
Diskette Drive (2030)
Hard Disk Drive (2035)
Keyboard Unit (2040)
Status Indicator (2060)
LCD Assembly (2070)
Speaker Shield Assembly (2080)
Audio Card (2085)
Interposer Card (2090)
DC/DC Card (2100)
Backup Battery (2110)
Standby Battery (2105)
System Board Assembly (2120)
Notes:
1. When handling the PCMCIA slot assembly, be careful
not to disassemble any part of it. The slot assembly
is not solidly fixed when it is removed from the
system board or the FRU.
In step ▌4▐, gently pull up the bottom of the center
area of the connector board edge with your fingers.
2. The screw stand located each corner of the PCMCIA
slot, is easy to remove. Make sure that the screw
stand is located when replace the slot. Do not
replace the slot without the screw stand.
Use the following table for reference when replacing parts.
Step Location (Quantity) Length
▌1▐ PCMCIA slot, upper (2) 12 mm
▌2▐ PCMCIA slot, lower (2) 14 mm
Note: Make sure you use the correct screw.
286 IBM Mobile Systems HMM
To Next Page
Loading...
Need help?
General
