IBM AS/400 User Manual

AS/400 Prompt AS/400 Parameter 4680 Link Parameter
Local location
address
LOCADR 4680 SESSION ADDRESS parameter must match the LOCADR
parameter specified on the AS/400 CRTDEVRTL command. Session
address 01 is reserved for host command processor sessions.
SSCP identifier SSCPID 4680 SSCP ID parameter must match the SSCPID parameter specified on
the AS/400 CRTCTLRTL command.
Matching AS/400 parameters for 4684 retail controllers
You must coordinate parameter values with the AS/400 and the 4684 retail controller when running IBM
Retail Industry Programming Support Services (RIPSS). The following table lists those parameters.
AS/400 parameters are listed in alphabetical order; the commands on which the parameters are specified
are included in the rightmost column of the table.
For more information about configuring for RIPSS on the 4684, see the IBM Retail Industry Programming
Support Services: Planning and Installation Guide, SC33-0650.
To configure the AS/400 to a 4684 controller:
v See “Examples: Connecting AS/400 to a 4690 retail controller” on page 75 for an example of an AS/400
connecting to a 4690 retail controller.
v Use the following table to connect to a 4690 retail controller.
AS/400 Prompt
AS/400
Parameter
RIPSS Configuration
Display RIPSS Prompt
LAN remote
adapter address
ADPTADR TRDLC Server Data Local node (Hex)
For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTCTLRTL command must match.
Local adapter
address
ADPTADR TRDLC Server Data Remote node (Hex)
For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTLINTRN command must match.
Destination service
access point
DSAP TRDLC Server Data Local SAP (Hex)
For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTCTLRTL command must match.
Duplex DUPLEX SDLC Server Data 4-wire constant RTS?
For SDLC connections, the values specified for
RIPSS and AS/400 configurations must match:
v If the RIPSS response is N, DUPLEX(*HALF)
must be specified for the CRTLINSDLC
command.
v If the RIPSS response is Y, DUPLEX(YES) must
be specified for the CRTLINSDLC command.
74 Version 5

IBM AS/400 Specifications

General

Brand	IBM
Model	AS/400
Category	Network Hardware
Language	English