Table 7. Unit type and locations
Unit type (Utttt.mmm) Link to location information
U8231.E2B 8231-E2B Locations
Location code labels
The location code label represents a physical part of the server. The following table describes the prefixes
of location code labels.
Note: These labels apply to system units only.
Table 8. Prefixes of location code labels for system units
Prefix Description Example
A Air-moving device Fan, blower
C Card connector IOP, IOA, DIMM, processor card
D Device Diskette, control panel
E Electrical Battery, power supply, ac charger
L Logical path SAS target Integrated drive electronics (IDE) address, Fibre
Channel LUN
N Horizontal placement for an empty rack location
P Planar System backplane
T Port, external cable
U Unit
V Virtual planar
W Worldwide unique ID
X EIA value for an empty rack location
Y Firmware FRU
Worldwide unique identifier
The location code label for the worldwide unique identifier consists of the prefix W followed by a
maximum of 16 uppercase hexadecimal digits with no leading zeros. A location code might not consist of
a worldwide unique identifier. When present, the worldwide unique identifier location label follows the
location label of the resource that interfaces with the resource that has the worldwide unique identifier,
usually a port.
8231-E2B locations
Use this information to help you map a location code to a position on the unit.
The following diagrams show field replaceable unit (FRU) layouts in the system. Use these diagrams with
the following tables.
Rack views
Finding parts, locations, and addresses 29
To Next Page
Loading...
Need help?
General