Table 2. Slot priorities for the FC EJ0K (continued)
Feature code Description Slot priorities
for two
processors
Slot priorities
for three
processors
Slot priorities
for four
processors
Maximum
number of
adapters
supported
Note: The C9 and C12 slots are used for controlling the internal disk drive bays and have limited
availability for attaching a 5887 disk drive enclosure or an ESLL or ESLS storage enclosure.
Table 3 on page 47 shows the PCIe3 cable adapter slots and priorities for the 9040-MR9 system. The
PCIe3 cable adapter is used to connect your system to the PCIe3 6-slot fanout module in your EMX0 PCIe
Gen3 I/O expansion drawer.
Table 3. PCIe3 cable adapter slots and priorities
Feature code Description Slot priorities
for two
processors
Slot priorities
for three
processors
Slot priorities
for four
processors
Maximum
number of
adapters
supported
EJ08 PCIe to optical
CXP converter
adapter (FC
EJ08; CCIN
2CE2); Adapter
part number:
041T9901
11, 8 10, 7 11, 8, 5, 10, 7,
4
11, 8, 5, 3, 10,
7, 4, 2
4/6/8
Connector locations for the 9080-M9S system
Learn about connector locations for the 9080-M9S system.
Figure 42. Rear view of the 9080-M9S system
Table 4 on page 48 shows the slot priorities for the FC EJ0M and EJ14 adapters, which support the
attachment of SAS hard disk drives (HDDs) and solid-state devices (SSDs) in the 9080-M9S system.
Reference information
47
To Next Page
Loading...
Need help?
General