Attaching the bracket extensions to the switch
Complete the following steps to attach the bracket extensions to the switch. See
Figure 5 on page 11 for detailed illustrations of the parts.
1. Position the right bracket extension (1) along the side of the switch as shown
in Figure 7.
1 - Extension brackets
2 - Screws, 8-32 x 5/16-in., flathead Phillips
2. Insert four 8-32 x 5/16-in. flathead screws (2) through the vertically aligned
holes in the extension and then into the holes on the side of the switch. Use the
upper and lower screw holes, leaving the center holes empty.
3. Repeat steps 1-2 to attach the left bracket extension to the left side of the
switch.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
Installing the switch in the rack
Complete the following steps to install the switch in the rack. See Figure 5 on page
11 for detailed illustrations of the parts.
1. Position the switch in the rack, as shown in Figure 8 on page 14, providing
temporary support under the switch until the rail kit is secured to the rack.
2
2
1
b42r007
Figure 7. Attaching the bracket extensions to the switch
Chapter 2. Installing and configuring the switch 13
To Next Page
Loading...
Need help?
General