1 - Extension brackets
2 - Screws, 8-32 x 5/16-in., flathead Phillips
2. Insert four 8-32 x 5/16-in. flathead screws (2) through the vertically aligned
holes in the extension bracket, and then into the holes on the side of the switch.
Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat steps 1-2 to attach the left bracket extension to the left side of the
switch.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lbs (17 cm-kgs).
Installing the switch in the rack, rear-flush
Complete the following steps to install the switch in the rack, flush to the rear. See
Figure 5 on page 11 for detailed illustrations of the parts.
1. Position the switch in the rack, as shown in Figure 14 on page 19, providing
temporary support under the switch until the rail kit is secured to the rack.
1
2
2
b42r013
Figure 13. Attaching the extension brackets to the front of the switch
18 SAN42B-R Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General