SAN48B-5 management
You can use the management functions built into the SAN48B-5 to monitor the
fabric topology, port status, physical status, and other information to help you
analyze switch performance and to accelerate system debugging.
The switch automatically performs power-on self-test (POST) each time it is turned
on. Any errors are recorded in the system error log. For more information about
POST, see “POST and boot specifications” on page 28.
For information about upgrading the version of Fabric OS installed on your switch,
see the Fabric OS Administrator’s Guide. You can manage the switch using any of
the management options listed in Table 6. Please refer to the Fabric OS Command
Reference for more information on the CLI commands.
Table 6. Management options for the SAN48B-5
Management tool Out-of-band support In-band support
Command Line Interface (CLI)
Up to two admin sessions and four
user sessions simultaneously. For more
information, refer to the Fabric OS
Administrator’s Guide and the Fabric OS
Command Reference.
Ethernet or serial
connection
IP over Fibre Channel
Web Tools
For information, refer to the Web Tools
Administrator’s Guide.
Ethernet or serial
connection
IP over Fibre Channel
Standard SNMP applications
For information, refer to the MIB
Reference Manual.
Ethernet or serial
connection
IP over Fibre Channel
Management Server
For information, refer to the Fabric OS
Administrator’s Guide and the Fabric OS
Command Reference.
Ethernet or serial
connection
Native in-band interface
(over HBA only)
Network Advisor (option to purchase)
For information, refer to the Network
Advisor documentation set.
Ethernet or serial
connection
IP over Fibre Channel
30 SAN48B-5 Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General