IBM System x3650 M3 4255 User Manual

Removing a USB hypervisor memory key
To remove the USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 22).
3. Remove the cover (see “Removing the cover” on page 45).
4. Locate the SAS riser-card assembly, which is near the left front corner of the
server.
5. Push the blue locking collar on the USB hypervisor connector back toward the
SAS riser-card to unlock it from the connector.
6. Pull the hypervisor memory key from the USB hypervisor connector.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 139.
Note: You must configure the server not to look for the hypervisor USB drive. See
Chapter 3, “Configuring the server,” on page 143 for information about disabling
hypervisor support.
134 System x3650 M3 Types 4255, 7945, and 7949: Installation and User’s Guide

IBM System x3650 M3 4255 Specifications

General

Brand	IBM
Model	System x3650 M3 4255
Category	Server
Language	English