Error messages
Symptom or error FRU or action, in sequence
Device address conflict. 1. Load “Setup Defaults” in
IBM BIOS Setup Utility.
2. Backup battery.
3. System board.
Allocation error for device. 1. Load “Setup Defaults” in
IBM BIOS Setup Utility.
2. Backup battery.
3. System board.
Failing bits: nnnn. 1. DIMM.
2. System board.
Invalid system configuration
data.
1. DIMM.
2. System board.
I/O device IRQ conflict. 1. Load “Setup Defaults” in
IBM BIOS Setup Utility.
2. Backup battery.
3. System board.
Operating system not found. 1. Check that the operating
system has no failure and is
installed correctly.
2. Enter IBM BIOS Setup
Utility and see whether
the hard disk drive and
the diskette drive are
properly identified.
3. Reseat the hard disk drive.
4. Reinstall the operating
system.
5. Diskette drive.
6. Hard disk drive.
7. System board.
Hibernation error. 1. Restore the system
configuration to what it
was before the computer
entered hibernation mode.
2. If memory size has been
changed, re-create the
hibernation file.
Fan error. Fan.
Thermal sensing error. System board.
Authentication of system
services failed. Press <Esc> to
resume.
The IBM Predesktop Area in
the HDD is corrupted.
Restore it from a recovery
CD.
Symptom-to-FRU index
60 MT 2373/2374/2375/2376/2378/2379
To Next Page
Loading...
Need help?
General