August 15, 2017
© Copyright IBM Corporation, 2017 Page 112 of 117
depends on the amount of data exported. For example, if you estimate you would normally export
about 600GB data and use JA media, the data could fit on as few as 2 physical volumes, so you may
want to set this field to 2. It is possible that an additional volume may be used depending on drive
and physical volume availability when data is copied from the cache to physical tapes during a copy
export operation.
6. Set up the reclamation policies by entering values in the Days without Access, Age of Last Data
Written, Days Without Data Inactivation and Maximum Active Data fields. A value of 1 to 365
days may be specified. If you do not want a policy to be included, set the field to 0. In this example,
all reclaim values have been set to 0. Note: these fields do not apply to offsite reclamation.
7. Select the OK button.
To Next Page
Loading...
Need help?
General
