Attach the cables
Drives with 68 pin connectors
Connect the SCSI cable and the power cable to the drive. The SCSI connector and power connector are
keyed for proper insertion.
Drives with 80 pin connectors
80 pin drives are plugged into back planes of servers and require no cables. If you want to connect an 80
pin drive to a 68 pin SCSI cable, a converter is needed. Not all SCA converters support LVD mode.
Complete the hardware install
Ÿ Ensure that the SCSI bus is terminated at both ends. (LVD SCSI models do not have onboard active
termination. You must supply an external LVD compatible terminator.)
Ÿ Verify proper cable connection to the SCSI controller.
Ÿ Connect all cables.
Ÿ Replace the computer system cover.
Ÿ Plug the power cord into the wall.
IBM storage products
Page 12
IBM Technology Group Support Center 07N5612IG10
To Next Page
Loading...
Need help?
General