7
6. Q&A (GPS Logger mode)
GPS signal cannot be received
When “GPS Select” is set to “Manual,” change it to
“Internal GPS” or “ON,” depending on the transceiver.
When “External GPS” is selected, conrm the
connection with the external GPS is successful.
L Receiving a signal may take time, depending on the
operating environment.
L When the transceiver is used indoors, signals from GPS
satellites may not be received, depending on where the
transceiver is installed, or the building’s surrounding
environment.
What is the recording interval?
The recording interval of the GPS Logger function
depends on the transceiver you are using. When
traveling on trains or cars, the recording interval
should be shortened. When traveling on foot, such
as when climbing mountains, the recording interval
should be set longer.
If the recorded log information is too detailed, set a
longer recording interval. If the log information is too
coarse, set a shorter recording interval.
When altitude information is not recorded?
Check that the GGA for which altitude information can
be obtained is set as a sentence to be recorded.
L The altitude information can be obtained when receiving
4 or more satellites.
L The more satellites the transceiver is receiving, the more
accurate the altitude information will be.
What models are equipped with the GPS Logger
Only mode?
The ID-31A/E and ID-51A/E series, the ID-52A/E, and
the IC-R30 are supported.
To Next Page
Loading...
Need help?
General
