4-5
D
Convenient functions for transmit
D
About CW reverse mode
CW-R (CW Reverse) mode receives CW signals with a
reverse side CW carrier point like that of LSB and USB
modes.
Use when interfering signals are near a desired signal
and you want to change the interference tone.
➥ During CW mode, push [CW] to select CW and CW-
R mode.
D
About CW pitch control
The received CW audio pitch and monitored CW audio
can be adjusted to suit your preference (300 to 900 Hz
in 25 Hz steps) without changing the operating fre-
quency.
➥ Rotate [CW PITCH] to suit your preference.
• Adjustable within 300 to 900 Hz in 25 Hz steps.
D
CW side tone function
When the transceiver is in the receive condition (and
the break-in function is OFF— p. 6-3) you can listen to
the tone of your CW signal without actually transmit-
ting.
This allows you to match your transmit signal exactly to
another station’s. This also convenient for CW prac-
tice. CW side tone level can be adjusted with [MONI
GAIN].
• Break-in function (p. 6-3)
➥ Push [VOX/BK-IN] several times to select the
break-in OFF, semi break-in and full break-in.
• “BK IN” or “F-BK IN” appears when the semi break-in
or full break-in function is set to ON, respectively.
4
RECEIVE AND TRANSMIT
To Next Page
Loading...
Need help?
General
