Icom IC-A22 Instruction Manual

i Weather channel scan
(U.S.A. version only)
@® Push [F] then [ENT-WxX] to select a weather channel.
@® Set [SQL] to the point where noise is just muted.
@ Push [F] then [A-UP SCAN] or [W-DN SCAN] to start
the scan.
» When a signal is received, the scan pauses until it disap-
pears, To resume the scan, rotate the tuning dial or push the
[A] or[¥] key.
* To change the scanning direction, rotate the tuning dial or
push the [ A] or [ W] key.
@ To stop the scan, push [CLR].
NOTE: A paused frequency or channel is not backed up
automatically. Push [CLR] to stop the scan then wait 2
sec. before turning power OFF, otherwise, the previous
frequency or channel appears when turning power ON
again.
KR CW
SCAN OPERATION 5
i Lockout channels
Memory and weather* channels can be specified to be
skipped for the memory and weather* channel scans,
respectively. The lockout channel function is only available
during scan operation.
ENGLISH
tockour Shows the lockout
@® then C2) channel.
(2YB 15.28
Memory channel 20 is Memory channel 20 is
scanned during memory skipped during memory
scan. scan.
@ Push [MR] to select memory mode; or, push [F] then
[ENT-WX] to select a weather channel.”
@ Select the desired channel to be locked out.
@ Push [F] then [@ LOCK OUT].
* “LOCK OUT appears.
* Lockout channels are skipped during scan.
@ To cancel the lockout setting, repeat above steps.
* Weather channel: U.S.A. version only.

Icom IC-A22 Specifications

General

Brand	Icom
Model	IC-A22
Category	Transceiver
Language	English