Icom IC-F3062T Sales Handbook

Scan
34
Priority scan. "Priority A" is selected channel in CH Atr in
Memory CH screen is used for the priority channel.
The scanning sequence is the same as Mode 2 (Prio-A)
above.
-The priority channel is selected automatically when
scan is cancelled.
-TX via [PTT] is performed in the priority channel.
Mode 2 (R.Sel):
Priority scan. The priority channel is selected by the
rotary selector.
The checked channels are scanned in sequence while
monitoring the priority channel.
-The priority channel is selected automatically when
scan is cancelled during scanning.
-TX via [PTT] is performed in the priority channel.
Mode 3 (R.Sel):
Priority scan. The priority channel is selected by the
rotary selector.
The scanning sequence is the same as Mode 2 (R.Sel)
above.
-The rotary selector channel is selected automatically
when scan is cancelled.
-TX via [PTT] is performed in the rotary selector
channel.
-The scan resumes after the Auto Reset Timer is
activated. In this case, the transmitted channel is set
for the priority channel.
Mode 2 (R.SelA):
Priority scan. The priority channel is selected by the
rotary selector.
The scanning sequence is the same as Mode 2 (R.Sel)
above.
- When scan is cancelled while receiving a signal, the
channel the signal is received on is selected
automatically.
- TX via [PTT] is performed in the channel that received
the signal.
- When a signal is received on other than priority
channel and transmits on that channel, scan is
cancelled on the transmitted channel. Then resume
the scan after the Auto Reset Timer is activated. In
this case, the transmitted channel is set for the
priority channel.
- TX via [PTT] is performed when receiving a signal,
transmission is made on that channel and resume
the scan after scan resume timer is activated. (Scan
won't be cancelled) And the same priority channel
(rotary selector channel) is used for the priority
channel even transmission is performed.
Mode 3 (R.SelA):
Priority scan. The priority channel is selected by the
rotary selector.
The scanning sequence is the same as Mode 3 (R.Sel)
above.
-TX via [PTT] is performed when receiving a signal,
transmission is made on the rotary selector channel
and resume the scan after scan resume timer is
activated. (Scan won't be cancelled)

Icom IC-F3062T Specifications

General

Brand	Icom
Model	IC-F3062T
Category	Transceiver
Language	English