TROUBLESHOOTING
8
18
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes ON.
•The battery is exhausted.
•Bad connection to the battery pack.
•Recharge the battery pack.
•Check the connection to the transceiver.
p. 15
p. 2
No sound comes from
the speaker.
•Squelch level is too deep.
•Volume level is too low.
•Speaker has been exposed to water.
•Set squelch to the threshold point.
•Set [OFF/VOL] to a suitable level.
•Drain water from the speaker.
p. 6
p. 7
—
Transmitting is impossi-
ble, or high power can-
not be selected.
•Some channels are for low power or re-
ceive only.
•The battery is exhausted.
•The output power is set to low or extra low.
•Change channels.
•Recharge the battery pack.
•Push [H/L] to select high power.
pgs.
5, 7
p. 15
p. 7
The displayed channel
cannot be changed.
•Lock function is activated. •Push [H/L•
LOCK] for 1 sec. to cancel the
function.
p. 6
Scan does not start. •“TAG” channel is not programmed. •Set the desired channels as “TAG” chan-
nels.
p. 12
Scan starts automati-
cally.
•Auto scan function is activated. •Cancel the auto scan function in SET
mode.
p. 14
No beep sounds. •Beep tone is turned OFF. •Turn the beep tone ON in SET mode. p. 13
Receive signal cannot
be understood.
•Optional voice scrambler is turned OFF.
•Scramble code is not set correctly.
•Turn the optional voice scrambler ON.
•Reset the scramble code.
p. 8
p. 8
To Next Page
Loading...
Need help?
General
