22
5
REPEATER OPERATION
■ Offset frequency
When communicating through a repeater, the transmit frequency is
shifted from the receive frequency by an amount determined by the
offset frequency.
q Push [8•
SET
] after pushing [A•
FUNC
] to enter
SET MODE
.
w Push [Y]/[Z] several times until “±” and
offset frequency appear.
e Rotate [VOL] to select the desired offset
frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is “MHz.”
r Push [#•
ENT
] to fix the offset frequency and exit
SET MODE
.
■ Subaudible tones
Some repeaters require subaudible tones to be accessed. Sub-
audible tones are superimposed over your normal signal and must
be set in advance.
q Push [8•
SET
] after pushing [A•
FUNC
] to
enter
SET MODE
.
w Push [Y]/[Z] one or more times until “rt”
appears.
e Rotate [VOL] to select the desired subaudible tone.
r Push [#•
ENT
] to enter the selected tone and exit set mode.
Available subaudible tone frequencies (unit: Hz)
USING
SET MODE
USING
SET MODE
67.0
69.3
71.9
74.4
77.0
79.7
82.5
85.4
88.5
91.5
94.8
97.4
100.0
103.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8
136.5
141.3
146.2
151.4
156.7
159.8
162.2
165.5
167.9
171.3
173.8
177.3
179.9
183.5
186.2
189.9
192.8
196.6
199.5
203.5
206.5
210.7
218.1
225.7
229.1
233.6
241.8
250.3
254.1
To Next Page
Loading...
Need help?
General
