31
8
SCAN OPERATION
■ Programmed scan
Programmed scan repeatedly scans between two user pro-
grammed frequencies (memory channels “1A–3A” and “1b–3b”) or
scans between upper and lower band edges. This scan is useful
for checking for signals within a specific frequency range such as
repeater output frequencies, etc.
q Push [D•
CLR
] to select VFO mode, if necessary.
w Push [5•
SCAN
] after pushing [A•
FUNC
] to start the scan, then a
selected scan edge appears as “P1”, “P2”, “P3” or “AL.”
• To change the scan edge, push [8•
SET
] after pushing [A•
FUNC
] sev-
eral times until the desired scan edge is appears.
• “AL” for full scan, “P1”, “P2” and “P3” for programmed scan be-
tween the programmed scan edge channels as “1A”–“1b”,
“2A”–“2b” and “3A”–“3b”.
• To change the scan direction, push [Y] or [Z].
• When “dial” is assigned [VOL], rotate [VOL] to change the scan di-
rection. (p. 51)
e Push [D•
CLR
] to stop the scan.
NOTE: Scan edges, 1A–3A/1b–3b, must be programmed in ad-
vance.
Program them in the same manner as regular memory
channels. (p. 25)
If the same frequencies are programmed into the scan edges,
programmed scan will not proceed.
To Next Page
Loading...
Need help?
General
