7
TONE SQUELCH AND POCKET BEEP
7-4
This function uses subaudible tones for calling, and
can be used as a “common pager” to inform you that
someone has called while you were away from the
transceiver.
1. Set the operating frequency, or select the memory
channel or Call channel.
2. Push [FUNC], and then push [SET] to enter the
Set mode.
3. Set the tone frequency, or DTCS code and DTCS
polarity.
4. Push [# ENT] to exit the Set mode.
5. Push [FUNC], and then push [TONE] several
times, until the icon of desired Tone function and
“ ” is displayed.
• “ ” and “ ”: CTCSS Pocket Beep function
• “ ” and “
”: DTCS Pocket Beep function
6. When a signal with matching tones or codes is
received, beep tones sound and “ ” blinks.
L To stop the beeps and blinking, push any key .
7. To cancel the tone or DTCS squelch, push
[FUNC], and then push [TONE] several times,
until the tone icon disappears.
Push
to turn ON the Pocket Beep function.
several times
, and then push
Tone squelch with
pocket beep
DTCS squelch with
pocket beep
Pocket Beep function
To Next Page
Loading...
Need help?
General
