Section 2
3
PROGRAMMABLE KEY FUNCTIONS
Programmable key functions
If you use the CS-V88 c L O n i n g s O f t w a r e (purchase
separately), you can assign the functions described
below to [P0], [P1], [P2], [P3], [TOP], [UP], and
[DOWN].
NOTE:
About the default settings of these keys, see the in-
struction manual that is provided with the transceiv-
er.
CH UP/DOWN
As described in the following topics, after pushing ➥
a programmed key, push [CH Up] or [CH Down] to
select an option, setting, and so on.
ZONE
Push this key, then select a desired zone by pushing ➥
[CH Up] or [CH Down].
What is “zone”?— Certain channels are grouped
together and assigned to a zone, according to their
intended use. For example, ‘Staff A’ and ‘Staff B’ are
assigned to a “Business” zone, and ‘John’ and ‘Cindy’
are assigned to a “Private” zone.
SCAN START/STOP
Push to start and cancel a scan. ➥
To select a scan group, hold down this key to display ➥
the scan groups, then push [CH Up] or [CH Down]
to select a desired group.
SCAN ADD/DEL (TAG)
Push to add the current channel to, or delete it from, ➥
the scan group.
1. Hold down to display the scan group, then push
[CH Up] or [CH Down] to select the desired one.
2. Push to add the channel to, or delete it from, the
selected scan group.
3. Hold down to exit the scan list selection mode.
While a scan is paused on a non-priority channel, ➥
push this key to delete the selected channel from the
scan group.
PRIORITY A (Prio A) CHANNEL, PRIORITY B (Prio B)
CHANNEL
Push to select the Prio A or Prio B channel. ➥
PRIORITY A
(Prio A)
CHANNEL (REWRITE),
PRIORITY B
(Prio B)
CHANNEL (REWRITE)
Push to select the Prio A or Prio B channel. ➥
Hold down ➥ [Prio A (Rewrite)] or [Prio B (Rewrite)]
to assign the operating channel to the Prio A or Prio
B channel.
MEMORY CHANNELS 1, 2, 3, 4
Push to directly select memory channel 1, 2, 3, or 4. ➥
MONI
Hold down to cancel the CTCSS (DTCS) mute. ➥
• The transceiver enters the “Audible” mode.
Push to turn OFF the function. ➥
LOCK
Hold down until “LOCK ON” is displayed to lock all ➥
programmable keys except [Moni], [Surveillance],
[Siren], and [Shift].
To turn OFF the Key Lock function, hold down until ➥
“LOCK OFF” is displayed.
HIGH/LOW
Push to temporarily select the transmit output pow- ➥
er.
C.Tone CH ENT
Push to enter the Continuous Tone Selection mode. ➥
Push [CH Up] or [CH Down] to select the tone fre-
quency or DTCS code.
TALK AROUND
Push to turn the Talk Around function ON or OFF. ➥
• The Talk Around function equalizes the transmit frequen-
cy to the receive frequency for transceiver-to-transceiver
communication.
WIDE/NARROW
Push to toggle the channel passband width between ➥
wide and narrow.
To Next Page
Loading...
Need help?
General
